7 of 11Image
This shot showcases the Noctua NH-C14 heatsink and its six heatpipes with dual 140mm fans, which are very quiet in operation. The system includes two sets of cables that slow the fans' spin speed from 1,200rpm to 900rpm or 700rpm. This promotes quietness, and a 140mm fan shifts a lot of air — 110.3 m3/hr at 1,200rpm, 83.7 m3/hr at 900rpm and 71.2 m3/hr at the slowest 700rpm setting. We used the 900rpm setting and the CPU temperature hardly shifted from 33 degrees C. Despite the overhang of the fans, we managed to install memory modules with the heatsink installed, although you could probably take the lower fan off to make DIMM installation a bit easier, as well providing greater noise reduction while retaining plenty of thermal headroom.
The Fractal Design Define R3 tower case has a clean appearance that carries through to the internals. The bulk of the inside is finished in black, but the eight drive bays are fitted with white slide-out trays that make it simple to swap drives in and out. This diminutive 80GB Intel X25-M SSD, secured using the supplied thumbscrews, looks a bit lost in all that space.
With the motherboard installed in the case and everything up and running, this machine is a riot of light. The Ballistix DIMMs include red LEDs (we didn't notice that when specifying them), and right next to them is a pair of seven-segment diagnostic panels. Cables are kept to a minimum thanks to the Scythe Stronger PSU's plug-in cable sets, so you only install as many sets as you need; this avoids having lots of redundant cabling to tidy away and potentially block the airflow. The green reflections off the top of the PSU casing will be explained later. One thing this photo doesn't show is that the fan on the Sweex-built graphics card was the noisiest component by far.