This post originally appeared on Smart Planet.
Ford is making the installation of its Sync software easier on its assembly lines courtesy of Wi-Fi.
To start, Ford is using Wi-Fi to deliver Sync software to its vehicles equipped with MyFord Touch technology. Ford's next-gen Sync software has a Wi-Fi receiver. The Wi-Fi assembly effort kicks off in Ford's Oakville, Ontario plant, which makes the 2011 Ford Edge and Lincoln MKX.
With an automobile Wi-Fi receiver the assembly line and vehicle can communicate. While this communication is largely untapped as an efficiency tool, Ford thinks it can save some money. In some respects, Ford had no choice, but to innovate with its Sync installation. It was becoming too difficult to scale Sync installations by stocking various modules as Ford rolled the software out globally.
For instance, Wi-Fi provisioning will enable Ford to stack standard Sync modules. The Wi-Fi installation should cut 90 unique part numbers, which have to be updated every time a Sync change is made. In a nutshell, Ford can now stock one Sync module and deliver options---apps, traffic, 20 languages, graphics, fuel and speed measurement settings and color scheme---via Wi-Fi. Previously, option combinations required a separate Sync module. The installation process takes about 8 minutes.
Ford said it has plans to roll out Wi-Fi installation on its assembly lines in its Chicago plant as well as other locations that will support the 2012 Ford Focus launch.
The biggest challenge with installing Wi-Fi in an assembly plant is the tuning since steel beams as well as high voltage cables can interfere with radio signals.
- Ford, University of Michigan students eye commute in cloud apps
- Ford, partners plot solar power system at Michigan plant
- Ford's aim: Make the 2011 Explorer sustainable
- Ford, Nuance aim to make Sync more conversational
- Ford turns your car into a Wi-Fi hot spot
- Ford: Solving the Internet’s ‘last inch’ problem at 70 mph